Lexus NX: System Diagram
SYSTEM DIAGRAM
READ NEXT:
System Description
SYSTEM DESCRIPTION
The power steering system generates torque through the operation of the motor and the reduction gear installed on the column shaft in order to assist steering effort.
The power
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use these procedures to troubleshoot the power steering system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT
Calibration
CALIBRATION TORQUE SENSOR ZERO POINT CALIBRATION (USING THE Techstream) NOTICE: Perform torque sensor zero point calibration if any of the following conditions occur:
The power steering ECU assembl
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL METER MIRROR SUB-ASSEMBLY (HEADUP DISPLAY) (a) Install the meter mirror sub-assembly (headup display) with the 4 screws. *a Screw *b Connector (b) Connect the connector. 2. INSTALL NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (a) Insta
Inspection
INSPECTION PROCEDURE 1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 5 (S) - 1 (GND) EV mode switch pushed and held Below 10 Ω
© 2016-2026 Copyright www.lexunx.com
