Lexus NX manuals

Lexus NX: Utility

Lexus NX Service Manual / Audio & Visual & Telematics / Telematics / Telematics System / Utility

UTILITY

CANCEL COMMUNICATION FUNCTION PAUSING

HINT:

This function is used to cancel communication function pausing mode

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Telematics / Utility / Cancel Communication Function Pausing.

Body Electrical > Telematics > Utility

Tester Display

Cancel Communication Function Pausing

ALL READINESS

HINT:

  • With "All Readiness", you can check whether or not the DTC judgment has been completed by using the Techstream.
  • You should check "All Readiness" after simulating malfunction symptoms or for validation after finishing repairs.

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Clear the DTCs even if no DTCs are stored.

Body Electrical > Telematics > Clear DTCs

(e) Turn the power switch off and wait for 2 minutes or more.

(f) Turn the power switch on (IG).

(g) Perform the DTC judgment driving pattern to run the DTC judgment.

(h) Enter the following menus: Body Electrical / Telematics / Utility / All Readiness.

Body Electrical > Telematics > Utility

Tester Display

All Readiness

(i) Input the DTC to be confirmed.

(j) Check the DTC judgment result.

Techstream Display

Description
If the judgment result shows Incomplete or N/A, perform the DTC confirmation driving pattern again.

Normal
  • DTC judgment completed
  • System normal

Abnormal
  • DTC judgment completed
  • System abnormal

Incomplete
  • DTC judgment not completed
  • Perform the driving pattern

N/A
  • Unable to perform DTC judgment
  • Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit
  • Perform the driving pattern

(k) Turn the power switch off.

READ NEXT:

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of

 Terminals Of Ecu

TERMINALS OF ECU DCM (TELEMATICS TRANSCEIVER) Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition I183-1 (+B) - I183-20 (E) Y - W-B Power source (

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Telematics / Trouble

SEE MORE:

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur: A communication malfunction DTC may be stored. The radio receiver assembly may not o

 Adjustment

ADJUSTMENT CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. PREPARE VEHICLE FOR FOG LIGHT AIM ADJUSTMENT (a) Prepare the vehicle: Ensure that there is no damage or deformation to the vehicle body arou

© 2016-2026 Copyright www.lexunx.com