Lexus NX: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
-
When a symptom indicates that a service is malfunctioning, use the Techstream to check whether the service subscription is active.
Click here
.gif)
| Symptom | Suspected Area | Link |
|---|---|---|
| Vehicle status cannot be checked using the application. | Proceed to "Remote Service Malfunction" | |
| Vehicle status alerts are not received by the application even if remote notification operation conditions are met. | Proceed to "Remote Service Malfunction" | |
| Vehicle cannot be operated remotely using the application. | Perform remote door lock and unlock registration and check if the problem symptom recurs | |
| Proceed to "Remote Service Malfunction" | |
| Symptom | Suspected Area | Link |
|---|---|---|
| Hybrid control system does not start by remote engine start function. | Proceed to "Remote Engine Starter does not Operate" | |
| Hybrid control system does not stop by remote engine stop function. | Proceed to "Remote Engine Starter does not Operate" | |
| Symptom | Suspected Area | Link |
|---|---|---|
| The multi-display assembly screen does not show a warning message even though a warning light turns on or the multi-information display indicates a warning. | Proceed to "Warning Notification Function Malfunction" | |
| The multi-display assembly screen shows a warning message even though no warning lights are on and the multi-information display does not indicate a warning. | Proceed to "Warning Notification Function Malfunction" | |
| The multi-display assembly screen shows a warning message different from the warning light or the multi-information display. | Proceed to "Warning Notification Function Malfunction" | |
READ NEXT:
Terminals Of Ecu
TERMINALS OF ECU DCM (TELEMATICS TRANSCEIVER) Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition I183-1 (+B) - I183-20 (E) Y - W-B Power source (
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Telematics / Trouble
Data List / Active Test
DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faul
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY (a) Attach the 2 claws to install the headlight dimmer switch assembly. (b) Connect the connector. 2. INSTALL TILT AND TELESCOPIC SWITCH Click here 3. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY Click here 4. INSTALL SPIRAL CABLE WI
Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH Click here 4. REMOVE BACK DOOR TRIM BASE Click here 5. REMOVE PULL HANDLE Click here 6. REMOVE BACK DOOR LOCK COVER Click here 7. REMOV
