Lexus NX: Voice Guidance does not Function
CAUTION / NOTICE / HINT
NOTICE:
When replacing the radio receiver assembly, always replace it with a new one.
If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
-
A communication malfunction DTC may be stored.
-
The radio receiver assembly may not operate normally.
PROCEDURE
| 1. | CHECK VOICE GUIDANCE SETTING |
(a) Check that the voice guidance settings are not off.
OK:
Voice guidance settings are not off.
| NG | | CHANGE VOICE GUIDANCE SETTINGS TO ON |
|
OK | | |
(a) Check that sound can be heard from a speaker.
OK:
Sound can be heard.
READ NEXT:
PROCEDURE 1. CHECK CONDITION (a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation. OK: Voice command is recognized normally. HINT:
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following
CAUTION / NOTICE / HINT HINT: If the operation of a cellular phone or the radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation. PROCEDURE 1.
SEE MORE:
INSTALLATION PROCEDURE 1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (a) Apply a light coat of engine oil to a new O-ring and install the O-ring to the camshaft timing oil control valve assembly. NOTICE: Do not damage the O-ring when installing. HINT: An O-ring is already installed in a new
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE FRONT DOOR UPPER OUTSIDE MOULDING PAD (a) Remove the front door upper outside moulding pad.
© 2016-2026 Copyright www.lexunx.com
