Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY
(a) Apply a light coat of engine oil to a new O-ring and install the O-ring to the camshaft timing oil control valve assembly.
NOTICE:
Do not damage the O-ring when installing.
HINT:
An O-ring is already installed in a new camshaft timing oil control valve assembly. So, the O-ring only needs to be coated with engine oil when the assembly is replaced with a new one.
(b) Install the camshaft timing oil control valve assembly to the cylinder head cover sub-assembly with the bolt.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
NOTICE:
- Replace with a new part if it is dropped or if it receives a strong impact.
- Make sure that the O-ring is not cracked or jammed when installing.
(c) Connect the camshaft timing oil control valve assembly connector.
2. INSPECT FOR OIL LEAK
Click here .gif)
3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY
Click here
READ NEXT:
Camshaft Position Sensor
ComponentsCOMPONENTS ILLUSTRATION *1 CAMSHAFT POSITION SENSOR *2 NO. 1 ENGINE COVER SUB-ASSEMBLY N*m (kgf*cm, ft.*lbf) : Specified torque Toyota Genuine Adhesive 1324, Three Bon
Crankshaft Position Sensor
ComponentsCOMPONENTS ILLUSTRATION *1 CRANKSHAFT POSITION SENSOR - - N*m (kgf*cm, ft.*lbf) : Specified torque Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent ★
SEE MORE:
Camshaft Position Sensor
ComponentsCOMPONENTS ILLUSTRATION *1 CAMSHAFT POSITION SENSOR *2 NO. 1 ENGINE COVER SUB-ASSEMBLY N*m (kgf*cm, ft.*lbf) : Specified torque Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent ★ Precoated part - - RemovalREMOVAL PROCEDURE 1. REMOVE NO. 1 E
Center Airbag Sensor Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Center Airbag Sensor Communication Stop Mode Any of the following conditions are met:
Communication stop for "Airbag" is indicated on the "Communication Bus Check" screen of the Techstream.
Click here
Communication system DTCs (DT
