Lexus NX manuals

Lexus NX: Voice is not Recognized

Lexus NX Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Navigation System / Voice is not Recognized

PROCEDURE

1.

CHECK CONDITION

(a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation.

OK:

Voice command is recognized normally.

HINT:

  • When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon. (Example: When "Cancel" is spoken, "Cancel" is displayed in the voice recognition result display area.)
  • If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
  • The system cannot recognize voice commands when multiple people are speaking simultaneously.
  • If the speaking speed is too fast or too slow, the recognition rate may decrease.
  • The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).
OK

END (VOICE RECOGNITION MAY BE DIFFICULT DUE TO SPEECH CONDITION)
NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

READ NEXT:

 Cellular Phone Registration Failure

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following

 Cellular Phone Inspection

CAUTION / NOTICE / HINT HINT: If the operation of a cellular phone or the radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation. PROCEDURE 1.

 Sound of Portable Player cannot be Heard from Speakers or Sound is Low

PROCEDURE 1. CHECK PORTABLE PLAYER SETTINGS (a) Check the portable player settings. (1) Check that the volume is not set to "0". (2) Check that mute is off. (b) Check that the sound of the po

SEE MORE:

 Components

COMPONENTS ILLUSTRATION *1 CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY *2 INSTRUMENT SIDE PANEL LH *3 INSTRUMENT SIDE PANEL RH *4 LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL *5 NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY *6 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-AS

 Speedometer Malfunction

DESCRIPTION The combination meter assembly receives vehicle speed signals from the brake booster with master cylinder assembly (skid control ECU) via the CAN communication line. The wheel speed sensors output voltages that vary according to the vehicle speed. The brake booster with master cylinder a

© 2016-2026 Copyright www.lexunx.com