Lexus NX: Antenna Cord
Lexus NX Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Antenna Cord
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ Power Back Door *B w/o Power Back Door *1 BACK DOOR FINISH COVER LH *2 BACK DOOR FINISH COVER RH *3 BACK DOOR LOCK COVER *4 BACK DOOR SIDE G
Removal
REMOVAL PROCEDURE 1. REMOVE ROOF HEADLINING ASSEMBLY Click here 2. REMOVE BACK DOOR CENTER GARNISH Click here 3. REMOVE BACK DOOR SIDE GARNISH LH Click here 4. REMOVE BACK DOOR SIDE GARNISH
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 5 ANTENNA CORD SUB-ASSEMBLY (a) Install the 2 grommets. (b) Attach the 3 clamps and install the washer hose to the clamp. (c) Connect the 4 connectors and install
SEE MORE:
Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter
DESCRIPTION The radio receiver assembly receives a vehicle speed signal from the combination meter assembly to control the ASL function. HINT:
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at the transist
Precaution
PRECAUTION POINTS TO NOTE WHEN SERVICING (a) Pay attention to the following points when servicing. (1) When disconnecting the cable from the negative (-) auxiliary battery terminal, "!" mark may appear on the multi-display assembly. In this case, restore the steering angle neutral point. Click here
© 2016-2026 Copyright www.lexunx.com
