Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 5 ANTENNA CORD SUB-ASSEMBLY
(a) Install the 2 grommets.
(b) Attach the 3 clamps and install the washer hose to the clamp.
(c) Connect the 4 connectors and install the No. 5 antenna cord sub-assembly.
2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
Click here .gif)
3. INSTALL BACK DOOR LOCK COVER (w/o Power Back Door)
Click here
4. INSTALL BACK DOOR LOCK COVER (w/ Power Back Door)
Click here
5. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)
Click here
6. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)
Click here
7. INSTALL PULL HANDLE (w/ Power Back Door)
Click here
8. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)
Click here
9. INSTALL BACK DOOR SIDE GARNISH RH
Click here
10. INSTALL BACK DOOR SIDE GARNISH LH
Click here
11. INSTALL BACK DOOR CENTER GARNISH
Click here
12. INSTALL ROOF HEADLINING ASSEMBLY
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL PROCEDURE 1. REMOVE DECK BOARD ASSEMBLY Click here 2. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 3. REMOVE REAR DECK FLOOR BOX Click here 4. REMOVE DECK FLOOR BOX LH Click here 5.
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL THEFT WARNING ULTRASONIC SENSOR (a) Attach the 4 clamps to install the theft warning ultrasonic sensor. (b) Install the 6 screws and connect the connector. 2. INSTALL MAP LIGHT ASSEMBLY Click here 3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL 4. INITIALI
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected
