Lexus NX: Combination Switch
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for 8 Inch *B for 10.3 Inch *1 CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY *2 INSTRUMENT PANEL FINISH PLATE *3 INSTRUMENT SIDE PANEL LH *4
Removal
REMOVAL PROCEDURE 1. REMOVE INSTRUMENT PANEL FINISH PLATE 2. REMOVE MULTI-DISPLAY ASSEMBLY WITH BRACKET Click here 3. REMOVE CONSOLE ARMREST ASSEMBLY Click here 4. REMOVE UPPER REAR CONSOLE PANE
Inspection
INSPECTION PROCEDURE 1. INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch C
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR WIPER MOTOR GROMMET (a) Apply MP grease to the entire circumference of the lip portion of the rear wiper motor grommet. HINT: Do not fill the hole with MP grease. Only apply MP grease to the grooves of the lip portion. *a Lip Portion
Main Switch Circuit
DESCRIPTION When the blind spot monitor main switch (combination switch assembly) is turned on, a signal is sent to the blind spot monitor sensor LH and the blind spot monitor indicator on the blind spot monitor main switch (combination switch assembly) illuminates. The blind spot monitor system ope
© 2016-2026 Copyright www.lexunx.com
