Lexus NX: Components
Lexus NX Service Manual / Audio & Visual & Telematics / Audio / Video / Amplifier Antenna / Components
COMPONENTS
ILLUSTRATION
| *A | w/ Power Back Door | *B | w/o Power Back Door |
| *1 | BACK DOOR CENTER GARNISH | *2 | BACK DOOR FINISH COVER LH |
| *3 | BACK DOOR FINISH COVER RH | *4 | BACK DOOR LOCK COVER |
| *5 | BACK DOOR SIDE GARNISH LH | *6 | BACK DOOR SIDE GARNISH RH |
| *7 | BACK DOOR TRIM BASE | *8 | BACK DOOR TRIM BOARD ASSEMBLY |
| *9 | NO. 1 AMPLIFIER ANTENNA ASSEMBLY | *10 | PULL HANDLE |
 | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH Click here 4. REMOVE BACK DOOR TRIM BASE (w/
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 1 AMPLIFIER ANTENNA ASSEMBLY (a) Attach the guide and install the No. 1 amplifier antenna assembly with the bolt. Torque: 8.3 N·m {85 kgf·cm, 73 in·lbf} (b) C
SEE MORE:
Back Camera Power Supply Failure (C1621)
DESCRIPTION This DTC is stored if the rear television camera assembly judges as a result of its self check that the signals or signal lines between the rear television camera assembly and multi-display assembly are not normal. DTC No. Detection Item DTC Detection Condition Trouble Area
Inspection
INSPECTION PROCEDURE 1. INSPECT MAP LIGHT ASSEMBLY (RAIN SENSOR CIRCUIT) (a) Remove the map light assembly. Click here (b) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition T6-1 (IG) - T6-14 (IG2
© 2016-2022 Copyright www.lexunx.com
