Lexus NX: Components
Lexus NX Service Manual / Steering / Steering Column / Multiplex Tilt And Telescopic Ecu / Components
COMPONENTS
ILLUSTRATION
| *1 | DECK FLOOR BOX LH | *2 | REAR DECK FLOOR BOX |
| *3 | NO. 3 DECK BOARD SUB-ASSEMBLY | *4 | NEGATIVE AUXILIARY BATTERY TERMINAL |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | MULTIPLEX TILT AND TELESCOPIC ECU | *2 | LOWER STEERING COLUMN COVER |
| *3 | BRACKET | - | - |
READ NEXT:
Installation
INSTALLATION PROCEDURE 1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU (a) Attach the claw and install the multiplex tilt and telescopic ECU to the bracket. (b) Install the bolt and multiplex tilt and te
Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the power switch is turned off, there may be a waiting time before disconnecting the auxiliary negative (-) battery terminal. Click here 2. CUST
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL REAR DOOR REAR WINDOW FRAME MOULDING LH (a) Install a new rear door rear window frame moulding LH. (b) Install a nose piece to an air
Manual(sos)switch
InspectionINSPECTION PROCEDURE 1. REMOVE MAP LIGHT ASSEMBLY Click here 2. INSPECT MAP LIGHT ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. *a Component without harness connected (Map Light Assembly) - - Resistance: Test
© 2016-2026 Copyright www.lexunx.com
