Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
- Do not replace the spiral with sensor cable sub-assembly with the battery connected and the power switch on (IG).
- Do not rotate the spiral with sensor cable sub-assembly when the following conditions are met: 1) The steering wheel is removed, 2) the battery is connected,and 3) the power switch is on (IG).
- Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
PROCEDURE
1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY (w/ Steering Heater)
Click here .gif)
2. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
Click here
3. INSTALL STEERING SHAKE DAMPER
(a) Install the 2 screws and steering shake damper to the steering wheel assembly.
4. INSTALL STEERING PAD SWITCH ASSEMBLY
Click here
5. INSTALL CRUISE CONTROL MAIN SWITCH
Click here
6. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
7. ADJUST SPIRAL CABLE
Click here
8. INSTALL STEERING WHEEL ASSEMBLY
(a) Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.
(b) Install the steering wheel assembly set nut.
Torque:
50 N·m {510 kgf·cm, 37 ft·lbf}
(c) Connect the connector.
(d) Connect the 2 connectors to the spiral cable with sensor sub-assembly.
9. INSTALL STEERING PAD
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 REAR DECK FLOOR BOX *3 NO. 3 DECK BOARD SUB-ASSEMBLY *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the power switch is turned off, there may be a waiting time before disconnecting the auxiliary negative (-) battery terminal. Click here 2. CUST
SEE MORE:
Sound Quality is Bad Only when Disc is Played (Volume is Too Low)
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly may not
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE 1. INSTALL LICENSE PLATE LIGHT ASSEMBLY LH (a) Attach the 2 claws to install the license plate light assembly LH. (b) Connect the connector.
