Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | REAR COIL SPRING LH | *2 | REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH |
| *3 | REAR LOWER COIL SPRING INSULATOR LH | *4 | REAR NO. 2 SUSPENSION ARM ASSEMBLY LH |
| *5 | REAR STABILIZER LINK ASSEMBLY LH | *6 | REAR SUSPENSION ARM COVER LH |
| *7 | REAR UPPER COIL SPRING INSULATOR LH | *8 | REAR STABILIZER CUSHION |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here 2. REMOVE REAR
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL REAR UPPER COIL SPRING INSULATOR
SEE MORE:
Rear Left Seat Heat Sensor Circuit (B14C3)
DESCRIPTION Power supply to the temperature sensor built into the rear seat cushion heater stops if one of the following occurs: 1) an open or short occurs in the temperature sensor circuit; or 2) the temperature sensor is damaged and its output value does not change. DTC No. Detection Item D
Components
COMPONENTS ILLUSTRATION *1 CANISTER PUMP MODULE *2 CHARCOAL CANISTER ASSEMBLY *3 FRONT FLOOR COVER CENTER LH *4 VENT LINE HOSE *5 AIR INLET LINE HOSE *6 PURGE LINE HOSE Specified torque: N*m (kgf*cm, ft.*lbf) ● Non-reusable part
© 2016-2026 Copyright www.lexunx.com
