Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *A | w/ Woofer | *B | w/o Woofer |
| *1 | BACK DOOR CENTER GARNISH | *2 | BACK DOOR LOCK COVER |
| *3 | BACK DOOR SIDE GARNISH LH | *4 | BACK DOOR SIDE GARNISH RH |
| *5 | BACK DOOR TRIM BASE | *6 | BACK DOOR TRIM BOARD ASSEMBLY |
| *7 | MULTIPLEX NETWORK DOOR ECU | *8 | PULL HANDLE |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH Click here 4. REMOVE BACK DOOR TRIM BASE Cli
Installation
INSTALLATION PROCEDURE 1. INSTALL MULTIPLEX NETWORK DOOR ECU (a) Connect the 2 connectors. Bolt Connector (b) Attach the guide and clip to install the multiplex network door ECU. NOTI
SEE MORE:
Generator Position Sensor Circuit (P0A4B-253-P0A4D-255)
DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate the resolver output signal is abnormal. The cause of this malfunction may be one of the following: Area Main Malfunction Description Step Inverter low-voltage circuit The connectors are not connected properly 2 Generator reso
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the fuel pump. Click here PROCEDURE 1. INSTALL FUEL SUCTION TUBE ASSEMBLY (a) Install a new gasket onto the fuel suction tube assembly. (b) With the paint mark facing the top of the vehicle, connect th
© 2016-2026 Copyright www.lexunx.com
