Lexus NX: Components
Lexus NX Service Manual / Vehicle Exterior / Door / Hatch / Power Back Door Warning Buzzer / Components
COMPONENTS
ILLUSTRATION
| *A | w/ Woofer | *B | w/o Woofer |
| *1 | BACK DOOR CENTER GARNISH | *2 | BACK DOOR LOCK COVER |
| *3 | BACK DOOR SIDE GARNISH LH | *4 | BACK DOOR SIDE GARNISH RH |
| *5 | BACK DOOR TRIM BASE | *6 | BACK DOOR TRIM BOARD ASSEMBLY |
| *7 | POWER BACK DOOR WARNING BUZZER | *8 | PULL HANDLE |
| ● | Non-reusable part | - | - |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH Click here 4. REMOVE BACK DOOR TRIM BASE Cli
Installation
INSTALLATION PROCEDURE 1. INSTALL POWER BACK DOOR WARNING BUZZER (a) Attach the clamp to install the power back door warning buzzer. (b) Connect the connector. 2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
SEE MORE:
Engine Coolant Temperature Circuit (P0115,P0117,P0118)
DESCRIPTION A thermistor, whose resistance value varies according to the engine coolant temperature, is built into the engine coolant temperature sensor. The structure of the sensor and its connection to the ECM are the same as those of the intake air temperature sensor. HINT: When DTC P0115, P0117
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE CYLINDER BOOT (a) Using a screwdriver with its wrapped with protective tape, remove the piston seal from the disc brake cylinder assemb
© 2016-2026 Copyright www.lexunx.com
