Lexus NX: Installation
Lexus NX Service Manual / Vehicle Exterior / Door / Hatch / Power Back Door Warning Buzzer / Installation
INSTALLATION
PROCEDURE
1. INSTALL POWER BACK DOOR WARNING BUZZER
(a) Attach the clamp to install the power back door warning buzzer.
(b) Connect the connector.
2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
Click here .gif)
3. INSTALL BACK DOOR LOCK COVER
Click here
4. INSTALL PULL HANDLE
Click here
5. INSTALL BACK DOOR TRIM BASE
Click here
6. INSTALL BACK DOOR SIDE GARNISH LH
Click here
7. INSTALL BACK DOOR SIDE GARNISH RH
Click here
8. INSTALL BACK DOOR CENTER GARNISH
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH side.
The procedure listed below is for the LH side.
PROCEDURE 1. PRECAUTION NOTICE: After turning the power
SEE MORE:
Lost Communication with Cruise Control Module Missing Message (U010487)
DESCRIPTION The millimeter wave radar sensor assembly communicates with the forward recognition camera via CAN communication. If a communication error is detected between the forward recognition camera and millimeter wave radar sensor assembly, the millimeter wave radar sensor assembly stores this D
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH (a) Attach the 3 claws to install the front door outside moulding sub-assembly LH. (b) In
© 2016-2026 Copyright www.lexunx.com
