Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | DECK FLOOR BOX LH | *2 | NO. 3 DECK BOARD SUB-ASSEMBLY |
| *3 | REAR DECK FLOOR BOX | *4 | NEGATIVE AUXILIARY BATTERY TERMINAL |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT DOOR ARMREST SET BRACKET LH | *2 | FRONT DOOR BELT MOULDING ASSEMBLY LH |
| *3 | FRONT DOOR CHECK ASSEMBLY LH | *4 | FRONT DOOR FIX WINDOW GLASS LH |
| *5 | FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY LH | *6 | FRONT DOOR GLASS RUN LH |
| *7 | FRONT DOOR GLASS SUB-ASSEMBLY LH | *8 | FRONT DOOR INNER GLASS WEATHERSTRIP LH |
| *9 | FRONT DOOR INSIDE HANDLE BEZEL PLUG LH | *10 | FRONT DOOR OUTSIDE MOULDING SUB-ASSEMBLY LH |
| *11 | FRONT DOOR REAR WINDOW FRAME MOULDING LH | *12 | FRONT DOOR SERVICE HOLE COVER LH |
| *13 | FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH | *14 | FRONT DOOR TRIM COVER LH |
| *15 | FRONT DOOR WEATHERSTRIP LH | *16 | NO. 1 BLACK OUT TAPE LH |
| *17 | NO. 2 BLACK OUT TAPE LH | *18 | NO. 3 BLACK OUT TAPE LH |
| *19 | OUTER MIRROR CONTROL ECU ASSEMBLY | *20 | POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL |
| *21 | UPPER DOOR FRAME GARNISH LH | *22 | RIVET |
| *23 | HOLE PLUG | *24 | BUTYL TAPE |
| | N*m (kgf*cm, ft.*lbf): Specified torque | ★ | Precoated part |
| ● | Non-reusable part | .png) | MP grease |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. PRECAUTION NOTICE: After the power switch off
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REPAIR INSTRUCTION (a) Clean the vehicle
SEE MORE:
Software Incompatibility with Body Control Module "B" (U1331)
DESCRIPTION This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors. DTC No. Detection Item DTC Detection Condition Trouble Area Note U1331 Software Incompatibility with Body Control
Components
COMPONENTS ILLUSTRATION *1 OUTSIDE MOULDING RETAINER *2 REAR DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY LH *3 REAR DOOR NO. 2 WEATHERSTRIP LH *4 REAR DOOR REAR UPPER OUTSIDE MOULDING LH *5 HOLE COVER - - ● Non-reusable part - - ILLUSTRATION *1 REAR DO
