Lexus NX: Exterior Panels / Trim

Lexus NX Service Manual / Vehicle Exterior / Exterior Panels / Trim

READ NEXT:

 Back Door Outside Garnish

 Components

COMPONENTS ILLUSTRATION *A w/ Woofer *B w/o Woofer *C w/o Power Back Door *D w/ Power Back Door *1 BACK DOOR CENTER GARNISH *2 BACK DOOR FINISH COVER LH *3 BACK DOO

 Removal

REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH Click here 4. REMOVE BACK DOOR TRIM BASE (w/ Po

SEE MORE:

 Manual(sos)switch

InspectionINSPECTION PROCEDURE 1. REMOVE MAP LIGHT ASSEMBLY Click here 2. INSPECT MAP LIGHT ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. *a Component without harness connected (Map Light Assembly) - - Resistance: Test

 Installation

INSTALLATION PROCEDURE 1. INSTALL REAR BUMPER SIDE SUPPORT LH (a) Attach the 2 claws to install the rear bumper side support LH. (b) Attach the clip. (c) Install the screw. 2. INSTALL REAR BUMPER SIDE SUPPORT RH HINT: Use the same procedure as for the LH side. 3. INSTALL REAR BUMPER S

© 2016-2026 Copyright www.lexunx.com