Lexus NX: Components
COMPONENTS
ILLUSTRATION
.png)
| *1 | DECK FLOOR BOX LH | *2 | NO. 3 DECK BOARD SUB-ASSEMBLY |
| *3 | REAR DECK FLOOR BOX | *4 | AUXILIARY BATTERY NEGATIVE TERMINAL |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT SEAT AIRBAG ASSEMBLY LH | *2 | FRONT SEAT CUSHION SHIELD LH |
| *3 | FRONT SEAT HEADREST SUPPORT | *4 | FRONT SEAT INNER CUSHION SHIELD LH |
| *5 | FRONT SEAT LOWER CUSHION SHIELD | *6 | SEATBACK FELT |
| *7 | SEPARATE TYPE FRONT SEATBACK COVER WITH PAD | *8 | HOG RING |
| | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
READ NEXT:
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the front seat airbag assemblies. PROCEDURE 1. INSPECT FRONT SEAT AIRBAG ASS
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
If the side airbag was deployed, replace the front seat airbag assembly LH, separa
Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
If the side airbag was deployed, replace the front seat airbag assembly LH, s
SEE MORE:
Reverse Signal Circuit between Radio Receiver Assembly and Navigation ECU
DESCRIPTION This circuit includes the navigation ECU and radio and display receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU) (a) Disconnect the I153 radio receiver assembly connector. (b) Disconnect the I173 navigation ECU
Components
COMPONENTS ILLUSTRATION *1 FRONT FENDER FRONT SPLASH SHIELD RH *2 FRONT FENDER LINER RH *3 FRONT FENDER MOULDING SUB-ASSEMBLY RH *4 NO. 1 MOULDING TAPE *5 NO. 2 MOULDING TAPE *6 WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY *7 WASHER HOSE *8 REAR WASHER HOSE *
© 2016-2026 Copyright www.lexunx.com
