Lexus NX: Components
Lexus NX Service Manual / Vehicle Interior / Supplemental Restraint Systems / Spiral Cable / Components
COMPONENTS
ILLUSTRATION
| *1 | DECK FLOOR BOX LH | *2 | NO. 3 DECK BOARD SUB-ASSEMBLY |
| *3 | REAR DECK FLOOR BOX | *4 | AUXILIARY BATTERY NEGATIVE TERMINAL |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | w/o Steering Heater | *B | w/ Steering Heater |
| *1 | LOWER STEERING COLUMN COVER | *2 | SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY |
| *3 | UPPER STEERING COLUMN COVER | - | - |
ILLUSTRATION
| *A | w/o Steering Heater | *B | w/ Steering Heater |
| *1 | STEERING SENSOR | *2 | SPIRAL CABLE SUB-ASSEMBLY |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precau
Inspection
INSPECTION PROCEDURE 1. INSPECT SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY NOTICE:
Do not remove the steering sensor from the spiral with sensor cable sub-assembly.
As the spiral with sensor cable sub
SEE MORE:
Vehicle Speed Signal Circuit between Stereo Component Amplifier and Combination Meter
DESCRIPTION The stereo component amplifier assembly receives a vehicle speed signal from the combination meter assembly to control the ASL function. HINT:
A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter assembly. The signal is changed to a pulse signal at
Switch Operation of Remote Touch not Accepted
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly may not
© 2016-2026 Copyright www.lexunx.com
