Lexus NX: Spiral Cable

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 AUXILIARY BATTERY NEGATIVE TERMINAL N*m (kgf*cm, ft.*lbf): Specified

 Removal

REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precau

 Inspection

INSPECTION PROCEDURE 1. INSPECT SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY NOTICE: Do not remove the steering sensor from the spiral with sensor cable sub-assembly. As the spiral with sensor cable sub

SEE MORE:

 Data List / Active Test

DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of

 On-vehicle Inspection

ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug. Click here PROCEDURE 1. PERFORM SPARK TEST (a) Check for DTCs. Click here NOTICE: If any DTC is output, perform troubleshooting procedures for that DTC.

© 2016-2023 Copyright www.lexunx.com