Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *A | w/ AVS | - | - |
| *1 | FRONT AXLE HUB SUB-ASSEMBLY LH | *2 | FRONT AXLE SHAFT NUT LH |
| *3 | FRONT DISC | *4 | FRONT DISC BRAKE CALIPER ASSEMBLY LH |
| *5 | FRONT FLEXIBLE HOSE | *6 | FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH |
| *7 | FRONT SPEED SENSOR LH | *8 | TIE ROD END SUB-ASSEMBLY LH |
| *9 | FRONT SHOCK ABSORBER ASSEMBLY WITH COIL SPRING | *10 | FRONT DRIVE SHAFT ASSEMBLY LH |
| *11 | FRONT BRAKE DUST COVER | - | - |
 | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 | MP grease |  | Do not apply lubricants to the threaded parts |
READ NEXT:
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunc
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no ma
SEE MORE:
Switch Operation of Remote Touch not Accepted
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly may not
Inspection
INSPECTION PROCEDURE 1. INSPECT AIR CONDITIONING THERMISTOR ASSEMBLY (HUMIDITY SENSOR) (a) for Glass temperature sensor: (1) Measure the resistance according to the value(s) in the table below. *a Component without harness connected (Air Conditioning Thermistor Assembly (Glass Temperature Sens
© 2016-2026 Copyright www.lexunx.com
