Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | ENGINE WATER PUMP ASSEMBLY | *2 | FAN AND GENERATOR V BELT |
| *3 | RADIATOR RESERVE TANK ASSEMBLY | *4 | V-RIBBED BELT TENSIONER ASSEMBLY |
| *5 | WATER BY-PASSS HOSE | *6 | NO. 2 WATER BY-PASS HOSE |
| *7 | GASKET | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with union nut wrench |
| ● | Non-reusable part | - | - |
READ NEXT:
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT HINT:
Water Pump Construction Evaporation Port and Drain Plug: *1 Evaporation Port *2 Mechanical Seal *3 Fluid Catch Pocket *4 Drai
Removal
REMOVAL PROCEDURE 1. DRAIN ENGINE COOLANT Click here 2. REMOVE FAN AND GENERATOR V BELT Click here 3. REMOVE RADIATOR RESERVE TANK ASSEMBLY (a) Slide the 2 clamps and disconnect the water by-pa
Installation
INSTALLATION PROCEDURE 1. INSTALL ENGINE WATER PUMP ASSEMBLY (a) Install a new gasket and the engine water pump assembly with the 5 bolts in the order shown in the illustration. Torque: 10 N·m {1
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR STABILIZER BUSHING (a) Install the 2 rear stabilizer bushings to the rear stabilizer bar on the outside of the bush stoppers as shown in the illustration. NOTICE:
Install the rear stabilizer bushing so that the bushing stopper of the rear stabilizer bar is f
Open in One Side of Bus 5 Branch Line
DESCRIPTION When the CAN bus main lines are normal (no open, short to ground, short to +B or short between lines) and there is an ECU or sensor on the "Communication Bus Check" screen that is indicated as not communicating or whose connection status on the "Communication Bus Check" screen changes in
© 2016-2026 Copyright www.lexunx.com
