Lexus NX: 2ar-fxe (cooling)

READ NEXT:

 Coolant

ReplacementREPLACEMENT PROCEDURE 1. DRAIN ENGINE COOLANT CAUTION: Do not remove the reservoir cap while the engine assembly and radiator assembly are still hot. Pressurized, hot engine coolant and st

 Cooling Fan Ecu

On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT COOLING FAN ECU (a) Check and ensure the following conditions: (1) The power switch is off. (2) The engine coolant temperature is less

 Cooling Fan Motor

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL REAR BUMPER SIDE SUPPORT LH (a) Attach the 2 claws to install the rear bumper side support LH. (b) Attach the clip. (c) Install the screw. 2. INSTALL REAR BUMPER SIDE SUPPORT RH HINT: Use the same procedure as for the LH side. 3. INSTALL REAR BUMPER S

 Manual(sos)switch

InspectionINSPECTION PROCEDURE 1. REMOVE MAP LIGHT ASSEMBLY Click here 2. INSPECT MAP LIGHT ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. *a Component without harness connected (Map Light Assembly) - - Resistance: Test

© 2016-2026 Copyright www.lexunx.com