Lexus NX: Diagnosis System
Lexus NX Service Manual / Vehicle Interior / Theft Deterrent / Keyless Entry / Theft Deterrent System / Diagnosis System
DIAGNOSIS SYSTEM
CHECK DLC3
(a) Check the DLC3.
Click here .gif)
INSPECT AUXILIARY BATTERY VOLTAGE
(a) Measure the auxiliary battery voltage with the power switch off.
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the auxiliary battery.
READ NEXT:
Engine Hood Courtesy Switch Circuit
DESCRIPTION The engine hood courtesy switch is installed together with the hood lock. This switch turns on when the engine hood is closed and turns off when the engine hood is opened. WIRING DIAGRAM
Horn Circuit
DESCRIPTION When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU (multiplex network body ECU) transmits a signal to cause the horn to sound a
Security Horn Circuit
DESCRIPTION When the theft deterrent system is switched from the armed state to the alarm sounding state, the main body ECU (multiplex network body ECU) transmits a signal to cause the security horn t
SEE MORE:
Removal
REMOVAL PROCEDURE 1. PRECAUTION Click here 2. CHECK FOR DTC (a) Check for DTCs. Click here NOTICE: Confirm that P0AA6 (Hybrid Battery Voltage System Isolation Fault) is not output before removing or installing an HV battery module. If this DTC is output, perform troubleshooting for this DTC firs
Purge Valve
ComponentsCOMPONENTS ILLUSTRATION *1 PURGE VSV *2 FUEL VAPOR FEED HOSE *3 NO. 2 FUEL VAPOR FEED HOSE - - RemovalREMOVAL PROCEDURE 1. REMOVE PURGE VSV (a) Disconnect the wire harness clamp and connector from the purge VSV. (b) Slide the 2 clamps and disconnect
© 2016-2026 Copyright www.lexunx.com
