Lexus NX: Diagnostic Trouble Code Chart
Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Intuitive Parking Assist System (w/ Intelligent Clearance Sonar System) / Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Intuitive Parking Assist System| DTC No. | Detection Item | Link |
|---|---|---|
| C1AE1 | Front Left Sensor Malfunction | |
| C1AE2 | Front Left Center Sensor | |
| C1AE3 | Front Right Center Sensor | |
| C1AE4 | Front Right Sensor Malfunction | |
| C1AE6 | Rear Left Sensor Malfunction | |
| C1AE7 | Rear Left Center Sensor Malfunction | |
| C1AE8 | Rear Right Center Sensor Malfunction | |
| C1AE9 | Rear Right Sensor Malfunction | |
| C1AEC | Front Sensor Communication Malfunction | |
| C1AED | Rear Sensor Communication Malfunction | |
| U0073 | Control Module Communication Bus "A" Off | |
| U0155 | Lost Communication with Instrument Panel Cluster (IPC) Control Module | |
| U1000 | CAN Communication Failure (Message Registry) | |
.gif)
READ NEXT:
Front Left Sensor Malfunction (C1AE1)
DESCRIPTION The front corner ultrasonic sensor (FL sensor) is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultras
Front Left Center Sensor (C1AE2)
DESCRIPTION The front center ultrasonic sensor (FLC sensor) is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front center ultra
Front Right Center Sensor (C1AE3)
DESCRIPTION The front center ultrasonic sensor (FRC sensor) is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front center ultra
SEE MORE:
Additional Key cannot be Registered
DESCRIPTION If additional registration is not possible, a malfunction in the electrical key transmitter sub-assembly, certification ECU (smart key ECU assembly), power switch, No. 2 indoor electrical key antenna assembly (front floor), steering lock ECU (steering lock actuator assembly) or door cont
Inspection
INSPECTION PROCEDURE 1. INSPECT OUTER REAR VIEW MIRROR ASSEMBLY LH (a) Check the operation of the mirror surface. (1) Disconnect the outer rear view mirror assembly LH connector. *a Component without harness connected (Outer Rear View Mirror Assembly LH) (2) Apply auxiliar
© 2016-2026 Copyright www.lexunx.com
