Lexus NX: Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY LH
| (a) Check that the LED illuminates. (1) Apply 6.0 V (4 dry cell batteries in series) to each terminal and check the illumination state of the light. OK:
NOTICE: Do not apply more than 6.0 V. If the result is not as specified, replace the rear door outside handle assembly LH. |
|
.png)
2. INSPECT REAR DOOR OUTSIDE HANDLE ASSEMBLY RH
| (a) Check that the LED illuminates. (1) Apply 6.0 V (4 dry cell batteries in series) to each terminal and check the illumination state of the light. OK:
NOTICE: Do not apply more than 6.0 V. If the result is not as specified, replace the rear door outside handle assembly RH. |
|
READ NEXT:
Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
Centering bolts are used to mount the door hinge to the v
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
A bolt without a torque specification is shown in the sta
Rear Door Opening Trim Weatherstrip
ComponentsCOMPONENTS ILLUSTRATION *1 REAR DOOR OPENING TRIM WEATHERSTRIP LH *2 REAR DOOR SCUFF PLATE LH RemovalREMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WIPER SWITCH ASSEMBLY (a) w/o Auto Wiper System: Check the front wiper intermittent operation. (1) Connect a voltmeter positive (+) lead to terminal I125-3 (+1) and a negative (-) lead to terminal I124-4 (EW). *a Component with
Back Camera Disconnected (C1622)
DESCRIPTION This DTC is stored if the radio receiver assembly judges that the signals or signal lines between the television camera assembly and the multi-display assembly are not normal as a result of its self check. DTC No. Detection Item DTC Detection Condition Trouble Area C1622 B
