Lexus NX: Diagnostic Trouble Code Chart
Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Parking Assist Monitor System / Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Parking Assist Monitor System| DTC No. | Detection Item | Link |
|---|---|---|
| C1611 | ECU Malfunction | |
| C1621 | Back Camera Power Supply Failure | |
| C1625 | Open or Short in Steering Angle Sensor +B | |
| C1626 | Steering Angle Sensor Failure | |
| C168D | Vehicle Information Unmatched | |
| C1691 | Back Camera Initialization Incomplete | |
| C1694 | Steering Angle Initialization Incomplete | |
| U0100 | Engine ECU Communication | |
| U0126 | Steering Sensor Communication | |
| U0140 | Lost Communication with Body Control Module | |
| U0163 | Lost Communication With Navigation Control Module | |
| U0233 | Lost Communication with Blind Spot Monitor Master Module | |
| U1000 | CAN Communication Failure (Message Registry) | |
| U1110 | Lost Communication with Clearance Sonar Module | |
.gif)
READ NEXT:
ECU Malfunction (C1611)
DESCRIPTION This DTC is stored if the rear television camera assembly judges that there is an internal malfunction as a result of its self check. HINT: The rear television camera assembly stores diffe
Back Camera Power Supply Failure (C1621)
DESCRIPTION This DTC is stored if the rear television camera assembly judges as a result of its self check that the signals or signal lines between the rear television camera assembly and multi-displa
Open or Short in Steering Angle Sensor +B (C1625)
DESCRIPTION This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates a power supply problem. DTC No. Detection Ite
SEE MORE:
System Description
SYSTEM DESCRIPTION GENERAL (a) The rear window defogger wires are attached to the inside of the back door glass and defog the window surface quickly when the rear window defogger switch on the air conditioning control assembly is pressed. The indicator light illuminates while the system is operating
Installation
INSTALLATION CAUTION / NOTICE / HINT NOTICE: When replacing the combination meter assembly, make sure to replace it with a new one. PROCEDURE 1. INSTALL COMBINATION METER ASSEMBLY (a) Connect the connectors and attach the clamp. *a Screw (b) Install the combination meter a
© 2016-2026 Copyright www.lexunx.com
