Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | FRONT FENDER MOULDING SUB-ASSEMBLY LH | - | - |
ILLUSTRATION
| *1 | NO. 1 MOULDING TAPE | *2 | NO. 2 MOULDING TAPE |
| ● | Non-reusable part | - | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE FRONT FENDER MOULDING SUB-ASSEMBLY LH H
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE NO. 1 MOULDING TAPE (a) Remove the
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL NO. 1 MOULDING TAPE (a) Clean the N
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT NO. 1 FOLD SEAT SWITCH ASSEMBLY (for Front Side) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Switch Condition Specified Condition 1 (HRSR) - 7 (E) RETURN RH switch pressed Below 1
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH (a) Check that the power switch is off. (b) Check that the cable is disconnected from the negative
© 2016-2025 Copyright www.lexunx.com
