Lexus NX: On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to follow the correct removal and installation procedures of the occupant classification ECU.

PROCEDURE

1. INSPECT OCCUPANT DETECTION ECU (for Vehicle not Involved in Collision)

(a) Perform a diagnostic system check.

Click here

2. INSPECT OCCUPANT DETECTION ECU (Vehicle Involved in Collision and Airbag not Deployed)

(a) Perform a diagnostic system check.

Click here

(b) Visually check for defects with the occupant classification ECU installed on the vehicle.

(1) The defects are as follows:

  • Cracks on the ECU housing
  • Dents on the ECU housing
  • Chips on the ECU housing
  • Cracks or other damage to the connector
  • Damage to the serial number

OK:

No defects are found.

HINT:

If any of the defects is found, replace the occupant classification ECU with a new one.

3. INSPECT OCCUPANT DETECTION ECU (for Vehicle Involved in Collision and Airbag is Deployed)

(a) Perform a diagnostic system check.

Click here

(b) Visually check for defects with the occupant classification ECU installed on the vehicle.

(1) The defects are as follows:

  • Cracks on the ECU housing
  • Dents on the ECU housing
  • Chips on the ECU housing
  • Cracks or other damage to the connector
  • Damage to the serial number

    OK:

    No defects are found.

HINT:

If any of the defects is found, replace the occupant classification ECU with a new one.

READ NEXT:

 Removal

REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precau

 Installation

INSTALLATION PROCEDURE 1. INSTALL OCCUPANT DETECTION ECU (a) Attach the claw to install the occupant detection ECU. NOTICE: If the occupant detection ECU has been dropped, or there are any cracks, den

 Occupant Classification System

SEE MORE:

 Back Camera Internal Circuit (C2A63)

DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the rear television camera assembly via CAN communication. DTC No. Detection Item DTC Detection Condition Trouble Area C2A63 Back Camera Internal Circuit A signal indicating a mal

 Fuel Pressure Regulator

ComponentsCOMPONENTS ILLUSTRATION *1 FUEL PRESSURE REGULATOR ASSEMBLY *2 FUEL PUMP ASSEMBLY WITH FILTER *3 NO. 1 FUEL SUB-TANK *4 NO. 1 FUEL SUCTION SUPPORT *5 FUEL SUCTION PLATE SUB-ASSEMBLY *6 NO. 2 FUEL TANK CUSHION *7 NO. 3 FUEL TANK CUSHION *8 FUEL PUMP

© 2016-2026 Copyright www.lexunx.com