Lexus NX: Display Malfunction (B15A6,B15B0)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the multi-display assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
| B15A6 | Display Malfunction | When one of the conditions below is met: -
RAM error
-
Drawing controller malfunction
| Multi-display assembly |
| B15B0 | Display Screen Malfunction | Picture circuit (TFT unit)malfunction | Multi-display assembly |
PROCEDURE
(a) Clear the DTCs.
Click here
Body Electrical > Navigation System > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output.
Click here
Body Electrical > Navigation System > Trouble Codes
OK:
No DTCs are output.
READ NEXT:
DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation ECU. DTC No. Detection Item DTC Detection Condition Trouble Area B15AD Navigation Processor Malfunction W
DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15C0 Short in GPS Antenna
DESCRIPTION The navigation ECU receives a vehicle speed signal from the combination meter assembly and information from the navigation antenna, and then adjusts the vehicle position on the map. The na
SEE MORE:
ADJUSTMENT PROCEDURE 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT (a) Check the brake pedal height. *1 Brake Pedal Pad - - *a Brake Pedal Height *b Measuring Plane of Floor Panel Brake pedal height from floor panel: 188.9 to 198.9 mm (7.44 to 7.83 in.) (b) Adjust the brake pedal
DESCRIPTION This DTC is stored when LIN communication between the multiplex network master switch assembly and main body ECU (multiplex network body ECU) stops for 10 seconds or more. DTC No. Detection Item DTC Detection Condition Trouble Area B1206 P/W Master Switch Communication Sto
© 2016-2026 Copyright www.lexunx.com
