Lexus NX manuals

Lexus NX: Navigation Processor Malfunction (B15AD)

Lexus NX Service Manual / Audio & Visual & Telematics / Navigation / Multi Info Display / Navigation System / Navigation Processor Malfunction (B15AD)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation ECU.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B15AD

Navigation Processor Malfunction

When either of the conditions below is met:

  • A short to ground, short to +B or open occurs in the gyro signal circuit
  • Gyro sensor malfunction

Navigation ECU

CAUTION / NOTICE / HINT

NOTICE:

When replacing the navigation ECU, always replace it with a new one.

If a navigation ECU which was installed to another vehicle is used, the following may occur:

  • A communication malfunction DTC may be stored.
  • The navigation ECU may not operate normally.

PROCEDURE

1.

CHECK FOR DTC

(a) Clear the DTCs.

Click here

Body Electrical > Navigation System > Clear DTCs

(b) Check for DTCs.

Click here

Body Electrical > Navigation System > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE NAVIGATION ECU

READ NEXT:

 Short in GPS Antenna (B15C0,B15C1)

DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15C0 Short in GPS Antenna

 Speed Signal Malfunction (B15C2)

DESCRIPTION The navigation ECU receives a vehicle speed signal from the combination meter assembly and information from the navigation antenna, and then adjusts the vehicle position on the map. The na

 Speaker Output Short (B15C3)

DESCRIPTION This DTC is stored when a malfunction occurs in the speakers. In addition, the radio receiver assembly detects a malfunction via the stereo component amplifier assembly. DTC No. Detec

SEE MORE:

 Driver Side Seat Position Sensor (B1653)

DESCRIPTION The seat position airbag sensor circuit consists of the airbag ECU assembly and seat position airbag sensor. DTC B1653 is stored when a malfunction is detected in the seat position airbag sensor circuit. DTC No. Detection Item DTC Detection Condition Trouble Area B1653 Dri

 Removal

REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. REMOVE TONNEAU COVER ASSEMBLY Click here 2. REMOVE DECK BOARD ASSEMBLY Click here 3. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY (a) Lift the front end of the rear

© 2016-2026 Copyright www.lexunx.com