Lexus NX: Disposal
DISPOSAL
PROCEDURE
1. DISPOSE OF BRAKE BOOSTER PUMP ASSEMBLY
(a) Remove the accumulator from the brake booster pump assembly.
(b) Secure the accumulator in a vise.
| (c) Using a hacksaw, make a cut in the side of the accumulator within location (A) to release the high-pressure gas.
CAUTION: Small pieces of metal may fly out when cutting into the accumulator. Put a cloth over the hacksaw when cutting the accumulator. Cut the accumulator slowly so that the gas will be released gradually. HINT: The gas is colorless, odorless and non-poisonous. |
|
READ NEXT:
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT NOTICE: If using a dropper to adjust the fluid amount, make sure that the dropper has not been used with mineral oils, water or deteriorated brake fluid.
Replacement
REPLACEMENT CAUTION / NOTICE / HINT HINT: There are 2 methods for brake fluid replacement: using the Techstream or not using the Techstream. NOTICE:
Perform fluid replacement with park (P) selected
SEE MORE:
Inspection
INSPECTION CAUTION / NOTICE / HINT NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
PROCEDURE 1. INSPECT REAR DRIVE SHAFT ASSEMBLY (a) Check that there is no excessive play in the radial direction of the inboard joint an
Rear Door LH Entry Unlock Function does not Operate
DESCRIPTION If the entry unlock function does not operate for the rear door LH only, but the entry lock function operates, the request code is being transmitted properly from the rear door LH. In this case, there may be a problem related to the unlock sensor (connection between the certification ECU
© 2016-2026 Copyright www.lexunx.com
