Lexus NX: Does not Recognize Voice Commands Performed to Contact Support Center

Lexus NX Service Manual / Audio & Visual & Telematics / Cellular Communication / Lexus Enform System / Does not Recognize Voice Commands Performed to Contact Support Center

PROCEDURE

1.

CHECK COMMUNICATION BASED VOICE RECOGNITION FUNCTION

(a) While paying attention to the condition of the spoken voice command, say "Find a gas station in New York" and check that voice recognition is operating normally.

HINT:

  • When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon. (Example: When "Find a gas station in New York" is spoken, "Find a gas station in New York" is displayed in the voice recognition result display area.)
  • If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
  • The system cannot recognize voice commands when multiple people are speaking simultaneously.
  • If the speaking speed is too fast or too slow, the recognition rate may decrease.
  • The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).

OK:

Voice command is recognized normally.

OK

END

NG

CONTACT SERVICE CENTER

READ NEXT:

 DCM Data Signal Circuit between Navigation ECU and DCM

DESCRIPTION This circuit is used to send and receive signals between the DCM (telematics transceiver) and radio receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (DCM [

 Manual(sos)switch

InspectionINSPECTION PROCEDURE 1. REMOVE MAP LIGHT ASSEMBLY Click here 2. INSPECT MAP LIGHT ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table belo

 Mayday Battery

SEE MORE:

 Control Module Communication Bus OFF (U0073,U0124,U0129,U0293)

DESCRIPTION The parking brake ECU assembly communicates with the hybrid vehicle control ECU, skid control ECU (brake booster with master cylinder assembly) and deceleration sensor (airbag ECU assembly) via CAN communication. DTC No. Detection Item DTC Detection Condition Trouble Area Memo

 DC / DC Converter Performance (P0A94-550,P0E32-564)

DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate a malfunction inside the inverter for the motor. The cause of this malfunction may be one of the following: Internal inverter malfunction Internal circuit malfunction in the inverter for the motor Malfunction in the sensors for inverter co

© 2016-2026 Copyright www.lexunx.com