Lexus NX: Lexus Enform System
Lexus NX Service Manual / Audio & Visual & Telematics / Cellular Communication / Lexus Enform System
- Precaution
- System Diagram
- How To Proceed With Troubleshooting
- Operation Check
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Confirm Cellular Phone Functionality
- Confirm Vehicle Headunit Functionality
- Does not Recognize Voice Commands Performed to Contact Support Center
- DCM Data Signal Circuit between Navigation ECU and DCM
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE: After the power switch is turned off, the radio receiver assembly records various types of memory and set
System Diagram
SYSTEM DIAGRAM
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedure to troubleshoot the LEXUS ENFORM system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE OIL SEAL (a) Apply MP grease to the lip of a new rear engine oil seal. NOTICE:
Do not allow foreign matter to contact the lip of the rear engine oil seal.
Do not allow MP grease to contact the dust seal.
(b) Using SST and a hammer, tap in the
Zero Point Calibration of Yaw Rate Sensor undone (C1210,C1336)
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) receives signals from the yaw rate and acceleration sensor (airbag ECU assembly) via CAN communication. The airbag ECU assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition using 2 cir
© 2016-2026 Copyright www.lexunx.com
