Lexus NX: Drive Shaft / Propeller Shaft
Lexus NX Service Manual / Drivetrain / Drive Shaft / Propeller Shaft
READ NEXT:
Drive Shaft System
Problem Symptoms TablePROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms ar
Components
COMPONENTS ILLUSTRATION *1 NO. 1 ENGINE UNDER COVER ASSEMBLY *2 REAR ENGINE UNDER COVER LH *3 REAR ENGINE UNDER COVER RH - - ILLUSTRATION *A w/o AVS *B w/ AVS *1
SEE MORE:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK FOR DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / AFS / Trouble Codes. Body Electrical > AFS > Trouble Codes (e) Check for DTCs. CLEAR DTC (a) Connect the Techs
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL STIFFENING CRANKCASE RING PIN NOTICE: It is not necessary to remove the ring pin unless it is being replaced. *a Protrusion Height (a) Using a plastic-faced hammer, tap in 2 new ring pins until they stop. Standard protrusion height: 4.3 to 5.3 mm (0.169 to 0
© 2016-2026 Copyright www.lexunx.com
