Lexus NX: Rear Drive Shaft Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 TAIL EXHAUST PIPE ASSEMBLY *2 EXHAUST PIPE SUPPORT *3 COMPRESSION SPRING - - N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here 2. REMOVE TAIL
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT NOTICE:
When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
HINT:
Use the same procedure for th
SEE MORE:
Low Output Signal of Rear Speed Sensor RH (C1273,C1274,C1466,C1467)
DESCRIPTION Each speed sensor detects the wheel speed and sends the signals to the skid control ECU (brake booster with master cylinder assembly). These signals are used for ABS control. DTCs C1273 and C1274 are cleared when the speed sensor sends a wheel speed signal or when Test Mode ends. DTCs C1
Operation Check
OPERATION CHECK INSPECT INDICATOR/WARNING LIGHT (a) Check the following indicators and warning lights. Indicator/Warning Light Switch Condition Specified Condition
*1: w/ Pre-collision System
*2: w/ Automatic High Beam System Brake warning light Power switch off → on (IG) Comes
© 2016-2026 Copyright www.lexunx.com
