Lexus NX: Dtc Check / Clear
Lexus NX Service Manual / Power Source & Network / Networking / Can Communication System / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK FOR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Central Gateway / Trouble Codes.
Body Electrical > Central Gateway > Trouble Codes(e) Read the DTCs.
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Central Gateway / Trouble Codes.
Body Electrical > Central Gateway > Trouble Codes(e) Clear the DTCs.
Body Electrical > Central Gateway > Clear DTCsREAD NEXT:
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When communication fails in any of the CAN bus wires (communication wires), a fail-safe function(s) operates. The fail-safe function that is specified for each s
Data List / Active Test
DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faul
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART CAN Communication System DTC No. Detection Item DTC Output from Link B1003 ECU Malfunction Central gateway ECU (network gateway ECU) U0199 Los
SEE MORE:
Steering Angle Initialization Incomplete (C1694)
DESCRIPTION This DTC is stored when the rear television camera assembly judges that the maximum steering angle has not been memorized (steering angle setting is incomplete). DTC No. Detection Item DTC Detection Condition Trouble Area C1694 Steering Angle Initialization Incomplete Ma
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT FLOOR COVER CENTER LH Click here 2. REMOVE CHARCOAL CANISTER ASSEMBLY (a) Disconnect the connector from the canister pump module. *1 Vent Line Hose *2 Air Inlet Line Hose *3 Purge Line Hose *4 Retainer *a Pull Out
© 2016-2026 Copyright www.lexunx.com
