Lexus NX: Dtc Check / Clear
Lexus NX Service Manual / Vehicle Interior / Supplemental Restraint Systems / Airbag System / Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes.
Body Electrical > SRS Airbag > Trouble Codes(f) Check for DTCs by following the prompts on the Techstream screen.
HINT:
Refer to the Techstream operator's manual for further details.
CLEAR DTC
(a) Turn the power switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the power switch on (IG).
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes.
(f) Clear the DTCs.
Body Electrical > SRS Airbag > Clear DTCs(g) Clear the DTCs by following the prompts on the Techstream screen.
HINT:
Refer to the Techstream operator's manual for further details.
READ NEXT:
Check Mode Procedure
CHECK MODE PROCEDURE NOTICE: Enter "Signal Check" from the "DTC Check" screen displayed on the Techstream to clear the output DTCs (both present and past). HINT:
DTCs can be stored more sensitively
Data List / Active Test
DATA LIST / ACTIVE TEST READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any part
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Airbag System DTC No. Detection Item Link B1000 Airbag ECU Malfunction B1610 Front Airbag Sensor (RH) B1612 Front Airbag Sensor Lost Co
SEE MORE:
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL NO. 3 MOULDING TAPE (a) Clean the No. 3 moulding tape installation surface. (1) When reusing the side mudguard LH, remove the double-si
Removal
REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before serving. Click here NOTICE: After turning the power switch off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal. Click here 2. DISCONNECT CABLE FROM NEGATIVE AUXILIA
© 2016-2026 Copyright www.lexunx.com
