- Torque sensor (electric power steering column sub-assembly) malfunction
- Power steering motor malfunction
- Power steering ECU assembly malfunction
Lexus NX: Fail-safe Chart
FAIL-SAFE CHART
If a problem occurs in the power steering system, the power steering assist will be stopped or the amount of power assist will be decreased to protect the system.
Power Steering System| Malfunction | Fail-safe Operation | Power Steering Warning Light | Buzzer |
|---|---|---|---|
| | Power steering assist stops or assist amount is limited | Red or yellow | Sounds intermittently or once |
| Power steering assist is temporarily limited | Yellow | Sounds once |
HINT:
- If the power steering assist stops, the power steering warning light (red) comes on.
- If the amount of power assist is reduced, the power steering warning light (yellow) comes on and a vibration or sound may occur.
- The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or being driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal when the steering wheel is not turned for approximately 10 minutes with the power switch on (READY).
- If the auxiliary battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist will be reduced and the power steering warning light will come on. In such cases, the amount of power assist returns to normal when the auxiliary battery voltage recovers.
READ NEXT:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. Th
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Power Steering System DTC No. Detection Item Warning Indicate Return-to-normal Condition Note Link C1511 Torque Sensor1 On Power switch on (IG) aga
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. CHECK STEERING EFFORT (TORQUE) CAUTION: These service operations may affect the SRS airbags. Be sure to read the precautionary notices concerning the SRS airbag syst
SEE MORE:
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. INSTALL REAR SEAT WIRE LH (for LH Side) (a) Attach the 2 clamps to install the rear seat wire LH. (b) Connect the 2 connectors. 2. INSTALL FOLD SEAT CONTROL
Power Steering Warning Light Circuit
DESCRIPTION The power steering ECU is connected to the combination meter via CAN communication. If any of the following conditions are detected, the power steering warning light remains on.
The circuit that supplies power source voltage to the power steering ECU assembly (terminal IG) is open.
© 2016-2026 Copyright www.lexunx.com
