Lexus NX: Frame Wire
Components
COMPONENTS
ILLUSTRATION
| *1 | AIR CLEANER CAP SUB-ASSEMBLY | *2 | AIR CLEANER CASE SUB-ASSEMBLY |
| *3 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | *4 | CONNECTOR COVER ASSEMBLY |
| *5 | ENGINE WIRE | *6 | INVERTER RESERVE TANK ASSEMBLY |
| *7 | NO. 1 ENGINE COVER SUB-ASSEMBLY | *8 | NO. 2 FRAME WIRE |
| *9 | RADIATOR SUPPORT OPENING COVER | *10 | WIRE HARNESS |
| *11 | UPPER INVERTER COVER | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | BATTERY TERMINAL CONNECTOR COVER | *2 | HYBRID BATTERY JUNCTION BLOCK ASSEMBLY |
| *3 | NO. 1 FRONT LOWER FLOOR HEAT INSULATOR | *4 | NO. 13 WIRING HARNESS PROTECTOR |
| *5 | NO. 14 WIRING HARNESS PROTECTOR | *6 | NO. 2 FRAME WIRE |
| *7 | NO. 2 HYBRID VEHICLE BATTERY SHIELD REINFORCEMENT | *8 | VOLTAGE INVERTER ASSEMBLY |
| *9 | BATTERY COVER LOCK STRIKER | *10 | STUD CLAMP |
| *11 | WIRE HARNESS CLAMP BRACKET A | *12 | WIRE HARNESS CLAMP BRACKET B |
| *13 | WIRE HARNESS CLAMP BRACKET C | *14 | WIRE HARNESS CLAMP BRACKET D |
| | N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
READ NEXT:
Charging
CHARGING PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing. Click here 2. INSPECT AUXILIARY BATTERY VOLTAGE Click here 3. PREPARATION FOR HV BATTERY CHARGING
SEE MORE:
Evaporative Emission System Leak Detection Reference Orifice Low Flow (P043E,P043F,P2401,P2402,P2419)
DTC SUMMARY DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory P043E Evaporative Emission System Leak Detection Reference Orifice Low Flow Reference orifice clogged during key-off EVAP monitor
Canister pump module
Connector/wire harness (Canister pump
Removal
REMOVAL PROCEDURE 1. REMOVE RADIATOR SUPPORT OPENING COVER Click here 2. REMOVE HOOD LOCK ASSEMBLY Click here 3. REMOVE CENTER HOOD CUSHION (a) Detach the 2 claws and remove the center hood cushion. 4. REMOVE HOOD TO FRONT FENDER SEAL LH (a) Detach the clip and remove the hood to front fend
