Lexus NX: Front Floor Footrest
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 COWL SIDE TRIM BOARD LH *2 DOOR SCUFF PLATE ASSEMBLY LH *3 FRONT FLOOR CARPET ASSEMBLY *4 NO. 4 DASH PANEL INSULATOR PAD (FRONT FLOOR FOOTREST)
Removal
REMOVAL PROCEDURE 1. REMOVE CONSOLE BOX ASSEMBLY Click here 2. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Click here 3. REMOVE COWL SIDE TRIM BOARD LH Click here 4. DISCONNECT FRONT FLOOR CARPET
Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 4 DASH PANEL INSULATOR PAD (FRONT FLOOR FOOTREST) (a) Install the No. 4 dash panel insulator pad (front floor footrest) with the clip. 2. CONNECT FRONT FLOOR CARP
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT STEERING PAD SWITCH ASSEMBLY (a) Measure the resistance according to the value(s) in the table below. *A w/ Lane Departure Alert System - - *1 SEEK+ *2 SEEK- *3 VOL+ *4 VOL- *5 MODE *6 VOICE *7 OFF HOOK *8 ON HOOK
Oxygen Sensor Heater Control Circuit Low (Bank 1 Sensor 2) (P0037,P0038,P0141,P102D)
DESCRIPTION Refer to DTC P0136. Click here HINT: When any of these DTCs are stored, the ECM enters fail-safe mode. The ECM turns off the heated oxygen sensor heater in fail-safe mode. Fail-safe mode continues until the power switch is turned off. DTC No. Detection Item DTC Detection Condi
© 2016-2026 Copyright www.lexunx.com
