Lexus NX: Installation

INSTALLATION

PROCEDURE

1. INSTALL NO. 4 DASH PANEL INSULATOR PAD (FRONT FLOOR FOOTREST)

(a) Install the No. 4 dash panel insulator pad (front floor footrest) with the clip.

2. CONNECT FRONT FLOOR CARPET ASSEMBLY

(a) Attach the 3 hooks and 2 fasteners to install the front floor carpet assembly.

*1

Hook

*2

Fastener

(b) Install the clip.

3. INSTALL COWL SIDE TRIM BOARD LH

Click here

4. INSTALL DOOR SCUFF PLATE ASSEMBLY LH

Click here

5. INSTALL CONSOLE BOX ASSEMBLY

Click here

READ NEXT:

 Lower Instrument Panel

 Precaution

PRECAUTION PRECAUTION FOR VEHICLE WITH AIRBAG (a) Some operations in this section may affect the airbag. Prior to performing the corresponding operations, read the SRS Precaution. Click here

 Components

COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING LH (a) Install a new front drive shaft hole snap ring LH. NOTICE: Do not damage the spline of the front drive inboard joint assembly LH. Front drive shaft hole snap ring LH should be installed completely. 2. INSTALL FRONT DRI

 Operation Check

OPERATION CHECK AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK (a) Turn the power switch on (IG). (b) Turn the headlight dimmer switch to the AUTO position. (c) Cover the automatic light control sensor. (d) Check that the taillights and low beam headlights come on. (e) Uncover the automatic light co

© 2016-2026 Copyright www.lexunx.com