Lexus NX: Hybrid Transaxle Fluid
Lexus NX Service Manual / Drivetrain / P314 (hybrid Transmission / Transaxle) / Hybrid Transaxle Fluid
READ NEXT:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. INSPECT HYBRID TRANSAXLE FLUID (a) Using a 10 mm hexagon socket wrench, remove the filler plug and gask
Replacement
REPLACEMENT PROCEDURE 1. REPLACE HYBRID TRANSAXLE FLUID (a) Be sure that the vehicle remains level and lift the vehicle. [*1] (b) Remove the No. 1 engine under cover assembly. Click here (c) Usin
Adjustment
ADJUSTMENT PROCEDURE 1. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY Click here 2. DRAIN HYBRID TRANSAXLE FLUID (a) Using a 10 mm hexagon socket wrench, remove the filler plug and gasket from the hyb
SEE MORE:
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL NO. 2 MOULDING TAPE (a) When using a new rear door rear upper outside moulding LH: (1) Clean the surface of a new rear door rear upper
Components
COMPONENTS ILLUSTRATION *1 TONNEAU COVER ASSEMBLY - - ILLUSTRATION *1 DECK BOARD ASSEMBLY *2 NO. 2 DECK BOARD SUB-ASSEMBLY *3 NO. 3 DECK BOARD SUB-ASSEMBLY - - ILLUSTRATION *1 DECK FLOOR BOX LH *2 DECK FLOOR BOX RH *3 NO. 1 TOOL BOX SUB-ASSEMBLY
© 2016-2026 Copyright www.lexunx.com
