Lexus NX: Initialization
INITIALIZATION
STEERING SENSOR ZERO POINT CALIBRATION
(a) Start the hybrid system.
(b) Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 seconds or more.
(c) Turn the power switch off.
READ NEXT:
Utility
UTILITY NOTICE: If any of the following parts has been replaced due to pre-collision system malfunction, those systems using those parts may be affected without performing necessary operations.
For
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the info
Terminals Of Ecu
TERMINALS OF ECU CHECK FORWARD RECOGNITION CAMERA NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the i
SEE MORE:
Precaution
PRECAUTION PRECAUTIONS FOR FRONT RADAR SENSOR SYSTEM (a) The millimeter wave radar sensor assembly may not be able to reliably detect the following objects:
Pylons made from plastic, etc., glass surfaces such as the entrance to a convenience store, low to the ground objects such as curbs, etc.
Installation
INSTALLATION PROCEDURE 1. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY (ABSORBER CONTROL SWITCH) (a) Install the integration control and panel assembly (absorber control switch) to the upper rear console panel sub-assembly with the 2 screws. HINT: The locations labeled A in the illustration are
© 2016-2026 Copyright www.lexunx.com
