Lexus NX: Inspection
INSPECTION
PROCEDURE
1. INSPECT QUICK HEATER ASSEMBLY
| (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: | Tester Connection | Condition | Specified Condition | | A-1 (B) - B-1 (E) | Always | Below 1 Ω | | A-2 (E) - B-2 (B) | Always | Below 1 Ω | | A-3 (B) - B-1 (E) | Always | Below 1 Ω | | A-3 (B) - B-2 (B) | Always | Below 1 Ω | -
If the result is not as specified, replace the quick heater assembly.
| | | *a | Component without harness connected (Quick Heater Assembly) | | *b | Connector A | | *c | Connector B | | |
READ NEXT:
INSTALLATION PROCEDURE 1. INSTALL QUICK HEATER ASSEMBLY (a) Install the quick heater assembly with the screw. (b) Attach the clamp and connect the 2 connectors. 2. INSTALL NO. 1 AIR DUC
PRECAUTION PRECAUTIONS FOR REFRIGERANT HFO-1234yf (R1234yf) (a) Compatibility (1) The parts used in the refrigerant cycle, etc. of the HFO-1234yf (R1234yf) system are not compatible with the conventio
SEE MORE:
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ENGINE COOLANT Click here 2. INSPECT ENGINE OIL Click here 3. INSPECT AUXILIARY BATTERY Click here 4. INSPECT AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY (a) Remove the air cleaner cap sub-assembly. (b) Remove the air cleaner filter element sub-assembly.
DESCRIPTION When selecting SPORT mode, the switch operation signal is sent to the ECM. Following this, the drive torque is optimally controlled to obtain a sporty feel in response to the driver's accelerator pedal operation. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (CAN BUS CHE
© 2016-2026 Copyright www.lexunx.com
