Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL STEERING PAD SWITCH ASSEMBLY
(a) Engage the 4 claws and 3 guide pins to install the steering pad switch assembly to the steering wheel sub-assembly.
(b) Install the 2 screws.
(c) Connect the steering pad switch connector to the No. 1 switch wire.
(d) Connect the steering pad switch connector to the spiral cable with sensor sub-assembly.
2. INSTALL CRUISE CONTROL MAIN SWITCH
Click here .gif)
3. INSTALL STEERING PAD
Click here
READ NEXT:
Precaution
PRECAUTION HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM Click here HANDLING PRECAUTIONS FOR STEERING COLUMN (a) When handling the electric power steering column sub-assembly: (1) Avoid any impact to
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of pr
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 REAR DOOR ARMREST SET BRACKET LH *2 REAR DOOR BELT MOULD
Inspection
INSPECTION PROCEDURE 1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY (a) Parking brake actuator assembly operation inspection (1) Apply voltage to the terminals of the parking brake actuator assembly and check that it operates as specified. OK: LH Tester Connection Parking Brake Actuator Assembl
© 2016-2026 Copyright www.lexunx.com
