Lexus NX: Installation

Lexus NX Service Manual / Vehicle Exterior / Lighting (ext) / Clearance Light Assembly (for Bulb Type Turn Signal Light) / Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.

PROCEDURE

1. INSTALL CLEARANCE LIGHT ASSEMBLY LH

(a) Attach the 2 claws to install the clearance light assembly LH.

(b) Install the 3 screws and clip.

(d) w/ Headlight Cleaner System:

(1) Attach the hose clamp.

(2) Attach the claw to connect the headlight cleaner hose.

2. INSTALL FRONT BUMPER ASSEMBLY

Click here

SEE MORE:

Installation

INSTALLATION PROCEDURE 1. INSTALL EXHAUST PIPE DAMPER (a) Install the exhaust pipe damper with the 2 bolts. Torque: 19 N·m {194 kgf·cm, 14 ft·lbf} 2. INSTALL HEATED OXYGEN SENSOR Click here 3. INSTALL FRONT EXHAUST PIPE ASSEMBLY (a) Using a vernier caliper, measure the free length of the co

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: If no problem symptoms are found when a DTC is output in the DTC check on the lane tracing assist, check each symptom by checking the suspected areas in the order they are listed. When replacing the combination meter assembly, always replace it with a new one. If

Lexus NX: Installation

READ NEXT:

Clearance Light Assembly (for Led Type Turn Signal Light)

Components

Removal

SEE MORE:

Installation

Problem Symptoms Table