Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL ACCELERATION SENSOR
(a) for RH side:
(1) Install the acceleration sensor with the 2 nuts.
Torque:
8.5 N·m {87 kgf·cm, 75 in·lbf}
NOTICE:
-
Avoid any impact to the acceleration sensor.
-
Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
(2) Connect the connector to the acceleration sensor.
(b) for LH side:
(1) Install the acceleration sensor with the 2 nuts.
Torque:
8.5 N·m {87 kgf·cm, 75 in·lbf}
NOTICE:
-
Avoid any impact to the acceleration sensor.
-
Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
(2) Connect the connector to the acceleration sensor.
2. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
Click here
3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Click here
4. INSTALL COWL SIDE TRIM BOARD LH
Click here
5. INSTALL DOOR SCUFF PLATE ASSEMBLY LH
Click here
READ NEXT:
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified
REMOVAL CAUTION / NOTICE / HINT NOTICE: While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or any door cour
SEE MORE:
ComponentsCOMPONENTS ILLUSTRATION *1 FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY - - RemovalREMOVAL PROCEDURE 1. REMOVE FORWARD RECOGNITION CAMERA Click here 2. REMOVE FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY NOTICE:
Do not touch the inner surface of the forward re
DESCRIPTION This DTC is stored when the parking assist ECU detects a signal indicating a malfunction in the side television camera assembly LH via CAN communication. DTC No. Detection Item DTC Detection Condition Trouble Area C2A61 Side Camera LH Internal Circuit A signal indicating
© 2016-2026 Copyright www.lexunx.com
