Lexus NX: Front Acceleration Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 ACCELERATION SENSOR *2 COWL SIDE TRIM BOARD LH *3 DOOR SCUFF PLATE ASSEMBLY LH *4 GLOVE COMPARTMENT DOOR ASSEMBLY *5 NO. 1 INSTRUMENT PANEL UNDER C
Removal
REMOVAL PROCEDURE 1. REMOVE DOOR SCUFF PLATE ASSEMBLY LH Click here 2. REMOVE COWL SIDE TRIM BOARD LH Click here 3. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 4. REMOVE GL
Inspection
INSPECTION PROCEDURE 1. INSPECT ACCELERATION SENSOR (a) Connect 3 1.5 V dry cell batteries in series. (b) Connect a positive (+) lead from the batteries to terminal 3 (SGB) and a negative (-) lead to
SEE MORE:
Terminals Of Ecm
TERMINALS OF ECM HINT: The standard voltage, resistance and waveform between each pair of the ECM terminals is shown in the table below. The appropriate conditions for checking each pair of the terminals is also indicated. The result of checks should be compared with the standard voltage, resistanc
Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING PAD SWITCH ASSEMBLY (a) Engage the 4 claws and 3 guide pins to install the steering pad switch assembly to the steering wheel sub-assembly. (b) Install the 2 screws. (c) Connect the steering pad switch connector to the No. 1 switch wire. (d) Connect the ste
© 2016-2025 Copyright www.lexunx.com
